News ID: 215244
Published: 0604 GMT May 18, 2018

Self-assembling 3D battery would charge in seconds

Self-assembling 3D battery would charge in seconds
A rendering of the 3D battery architecture (top; not to scale) with interpenetrating anode (grey, with minus sign), separator (green), and cathode (blue, plus sign), each about 20 nanometers in size. Below are their respective molecular structures.

The world is a big place, but it's gotten smaller with the advent of technologies that put people from across the globe in the palm of one's hand. And as the world has shrunk, it has also demanded that things happen ever faster — including the time it takes to charge an electronic device.

A cross-campus collaboration led by Ulrich Wiesner, professor of engineering at Cornell University, addressed this demand with a novel energy storage device architecture that has the potential for lightning-quick charges, according the

The group's idea: Instead of having the batteries' anode and cathode on either side of a nonconducting separator, intertwine the components in a self-assembling, 3D gyroidal structure, with thousands of nanoscale pores filled with the elements necessary for energy storage and delivery.

Wiesner said, "This is truly a revolutionary battery architecture.

"This three-dimensional architecture basically eliminates all losses from dead volume in your device.

"More importantly, shrinking the dimensions of these interpenetrated domains down to the nanoscale, as we did, gives you orders of magnitude higher power density.

“In other words, you can access the energy in much shorter times than what's usually done with conventional battery architectures.”

How fast is that? Wiesner answered that, due to the dimensions of the battery's elements being shrunk down to the nanoscale, by the time you put your cable into the socket, in seconds, perhaps even faster, the battery would be charged.

The architecture for this concept is based on block copolymer self-assembly, which the Wiesner group has employed for years in other devices, including a gyroidal solar cell and a gyroidal superconductor.

Joerg Werner, lead author on this work, had experimented with self-assembling photonic devices, and wondered if the same principles could be applied to carbon materials for energy storage.

The gyroidal thin films of carbon — the battery's anode, generated by block copolymer self-assembly — featured thousands of periodic pores on the order of 40 nanometers wide.

These pores were then coated with a 10 nm-thick, electronically insulating but ion-conducting separator through electropolymerization, which by the very nature of the process produced a pinhole-free separation layer.

That's vital, since defects like holes in the separator are what can lead to catastrophic failure giving rise to fires in mobile devices such as cellphones and laptops.

The next step is the addition of the cathode material — in this case, sulfur — in an amount that doesn't quite fill the remainder of the pores.

Since sulfur can accept electrons but doesn't conduct electricity, the final step is backfilling with an electronically conducting polymer — known as PEDOT.

While this architecture offers proof of concept, Wiesner said, it's not without challenges.

Volume changes during discharging and charging the battery gradually degrade the PEDOT charge collector, which doesn't experience the volume expansion that sulfur does.

Wiesner said, "When the sulfur expands, you have these little bits of polymer that get ripped apart, and then it doesn't reconnect when it shrinks again. This means there are pieces of the 3D battery that you then cannot access."

The group is still perfecting the technique, but applied for patent protection on the proof-of-concept work.


Security Key:
Captcha refresh
Page Generated in 0/1004 sec